S30 Prox Spot Lights

S30 Prox Spot Lights are part of Prox Spot Light Series from SmartVisionLights

• 30mm Barrel Style Housing
• M12 Quick Disconnect
• 5 watt HB high current LED running up to 1.4 Amps
• Built in SMART driver – No External Driver needed
• PNP and NPN strobe input
• Constant or Strobed Operation
• Manual Intensity Control – Integrated Potentiometer Dimming
• Remote Intensity Control – Analog 0-10VDC
• Standard optics provide tight focused light

The Prox Light® has one 5 watt high output, high current LED in a small 30mm barrel sensor housing. Housing is an industry standard M30x1.5 style used for proximity and photoelectric sensors. Prox Light® is available in light output of White, Red, Amber, Blue, Green, Cyan, IR and UV. Prox Light® includes an integrated constant current driver with a built in strobe input with option for PNP or NPN trigger control. No need for an external driver to control the light. The integrated driver also includes variable light intensity control. Light can be controlled by a manual potentiometer or a 0-10VDC analog signal.



Remote Head for Prox Spot Light Series:

Electrical Input:	Voltage - 24 VDC +/- 10% Maximum 6 Watts
Analog Intensity:	The output is adjustable from 10-100% of brightness by a 0 -10 VDC signal
Dimmable:	The output is manually adjustable from 0-100% of brightness by potentiometer
Continuous Mode:	Light will be in continuous mode by leaving signal on strobe input
Strobe:	PNP ? +5VDC or greater to activate. | NPN ? GND (<1VDC) to activate
Strobe Mode:	The Light will operate in either continuous or strobe mode. In strobe mode, the output pulse width will track the pulse width of the strobe pulse.

Wiring:


• If Analog 0-10 VDC is not used to control light intensity; +VDC (24VDC) must be connected to Analog
Input. Jumper Gray wire to Brown wire.
• 5 pin Standard M12 mating cable must be used.
• 0 – 10 VDC Analog controls intensity of light from 0-100%.
• PNP and NPN strobe – In strobe mode the light output will track the pulse width of the strobe input.
• Continuous mode – Leaving the NPN or PNP strobe signal in an active ON state.


Optical Performance:

Brightness distribution is measured using a CCD camera system. Three levels are expressed by areas and colors. The highest brightness is 100% and the other areas are assigned a percentage according to their measured value. Data is collected from testing red and white LED lights. An output difference between lights is normal and is the result of LED tolerances from the manufacturer.












Mounting:

Several mounting options for the Prox Spot Lights series, are available separately.