SOBL Back Light series: Back lights or diffuse illumination

• Built in SMART Driver – No External wiring to a driver
• 24VDC
• Continuous operation or Strobe mode
• Analog intensity via 0-10 VDC signal
• PNP and NPN Strobe input
• Red 625nm, IR 850nm and White
• 30mm Industrial Frame with 8mm T-Slot
• Standard M12 Industrial Connector

Color Options:
• 625nm – Red
• WHI - White
• 470nm – Blue
• 530nm – Green
• 850nm - IR

Wiring:

Smart Vision Lights cables are 5 conductors M12 in 18AWG wire. 18AWG is recommended for ALL OverDrive series and standard series lights. 18AWG is necessary to strobe lights at full current. Common M12 cables are 22AWG. Standard 22 AWG wires will not supply full power needed for our light. Smart Vision Lights recommends the cable from the power supply to the light be kept to a minimum.



• 5 pin Standard M12 mating cable must be used.
• 0 – 10 VDC Analog controls intensity of light from 10-100%. 0VDC = 10%, 10VDC = 100%
• PNP and NPN strobe – In strobe mode the light output will track the pulse width of the strobe input.
• Continuous mode – Leaving the NPN or PNP strobe signal in an active ON state. Non-OverDrive Lights.

Mounting:

Mounting options for SOBL Back Lights, consist of Standard 30mm Extrusion with 8mm T-slot.