LLP-H Diffuse Ring Light Panels Emulate Dome Lighting

The LLP-H series of edge lit light panels are designed to emulate the diffuse, multiple angle lighting achieved when using a large dome light or tent light. The advantage is that these panels are larger, brighter, and can be used at longer working distances. This is achieved through the precision laser cut hole in the center of the Large Light Panel for the camera to peer through.

LLP-H series Diffuse Ring Light Panels are fully customizable. Any dimension up to 1200mm x 1800mm (48"x72") can be achieved with the option for single or multiple hole designs. All of these advantages can be obtained at a fraction of the cost compared to dome lighting.

• Large LED Diffuse Ring Light with Thin profile
• M12 Quick Disconnect
• Driver built in – No external wiring to a driver
• Edge Lite White LED panel
• NPN & PNP strobe control
• Sizes Available up to 1200mm x 1800mm (48”x72”)
• Custom Sizes, Single or Multiple Holes

Wiring:

Smart Vision Lights cables are 5 conductors M12 in 18AWG wire. 18AWG is recommended for ALL OverDrive series and standard series lights. 18AWG is necessary to strobe lights at full current. Common M12 cables are 22AWG. Standard 22 AWG wires will not supply full power needed for our light. Smart Vision Lights recommends the cable from the power supply to the light be kept to a minimum.



• 5 pin Standard M12 mating cable must be used.
• 0 – 10 VDC Analog controls intensity of light from 10-100%. 0VDC = 10%, 10VDC = 100%
• PNP and NPN strobe – In strobe mode the light output will track the pulse width of the strobe input.
• Continuous mode – Leaving the NPN or PNP strobe signal in an active ON state.


Mounting:

Mounting for the LLP-H series light panels, consist of the Threaded Inserts in aluminium frame and M5 Screws.