LLP Back Lights

2nd Generation LLPs

• Large LED Backlight with Thin profile
• M12 Quick Disconnect
• Driver built in – No external wiring to a driver
• Edge Lite White LED panel
• NPN & PNP strobe control
• Sizes Available up to 1200mm x 1800mm (48”x72”)
• Custom Sizes

The new and improved second generation of LLP back lights and large diffuse ring light panels. These edge lit, white, back lights now feature four sided LED illumination for twice the intensity of our original versions. The new clear anodized thin profile frame is more industrial than ever. This increased rigidity and improved mounting system offer an advanced rugged design.
As always, 2nd Gen LLP’s feature a built-in driver with NPN-PNP triggering, analog intensity control, with the ability to run the light in constant or strobe mode. Standard, existing sizes are available with new part numbers in order of size from smallest to largest. Custom sizes are also available up to 1200mm x 1800mm (48?x72?).

Electrical Input:	Voltage: 24 VDC +/- 5%
NPN & PNP Input:	PNP ? +4VDC or greater to activate. NPN ? GND (<1VDC) to activate
Current:	See data sheet for individual light size.
Strobe Mode:	The Light will track the pulse width of the NPN/PNP input.
Analog Intensity:	The output is adjustable from 10-100% of brightness by a 0 -10 VDC signal

Wiring:


• 5 pin Standard M12 mating cable must be used.
• 0 – 10 VDC Analog controls intensity of light from 10-100%. 0VDC = 10%, 10VDC = 100%
• PNP and NPN strobe – In strobe mode the light output will track the pulse width of the strobe input.
• Continuous mode – Leaving the NPN or PNP strobe signal in an active ON state.


Mounting:

Mounting for the 2nd Generation LLP Series, consists of Threaded Inserts in aluminimum frame and M5 Screws.