HOBL series HIGH OUTPUT
High Power Back Lights for the machine vision industry

• Precise Intensity by monitoring temperature of LED’s
• Microprocessor regulation with status output signal
• Driver built in – No External wiring to a driver
• PNP and NPN Strobe input
• Continuous operation or Strobe mode
• Standard industrial 30mm Aluminum Extrusion Frame provides ease of mounting.

The HOBL series of LED Back Lights provide high output diffuse light. Lights are specifically engineered for high speed packaging and bottling lines.

Light uses a microprocessor to monitor the high power LED’s during operation. If an LED failure is detected, an LED error output becomes active. Temperature compensation circuit monitors the light and adjusts the intensity to maintain a stable level of output during operation.

Thin profile at only 30mm. Housing is constructed in aluminum extrusion to dissipate heat. Standard 8mm T-slot channel is used on light for ease of mounting.

Wiring:

Smart Vision Lights cables are 5 conductors M12 in 18AWG wire. 18AWG is recommended for ALL OverDrive series and standard series lights. 18AWG is necessary to strobe lights at full current. Common M12 cables are 22AWG. Standard 22 AWG wires will not supply full power needed for our light. Smart Vision Lights recommends the cable from the power supply to the light be kept to a minimum.


Important:
Please note the light will turn on for 5 seconds at power up. This is required to initialize the settings in the light. Light will not be ready for use till the 5 second power up is completed.

• 5 pin Standard M12 mating cable must be used.
• 0 – 10 VDC Analog controls intensity of light from 10-100%. 0VDC = 10%, 10VDC = 100%
• PNP and NPN strobe – In strobe mode the light output will track the pulse width of the strobe input.
• Continuous mode – Leaving the NPN or PNP strobe signal in an active ON state. Non-OverDrive Lights.


Mounting:

Mounting options for HOBL Back Lights, consist of Standard 30mm Extrusion with 8mm T-slot.