Diffuser Kit for Brick Light S75  & ODS75


(A) Diffuser

Smart Vision Lights have Diffuser kits available. Diffusers can widen the angle of light emission and reduce reflections. A Diffuser can be added in the field.

Diffuser Kits available for light series – L300, ODL300, S75, ODS75, S30, R80 & R130.

• Transmittance: single matte: 92%
• Transmittance: single white: 50%
• Color: Transparent or White
• Wavelength Transmission: 400~1000nm
• Thickness: 3mm (.118")

Heat
Operating Temperature Range - 30°F (-34°C) up to +16 0°F (71°C).
Material - General Purpose Acrylic

(B) Installation

Add on Diffuser or Polariser
New mounting for diffusers and polariser’s on L300 & ODL300 series Linear lights and S75 & ODS75 Brick lights. The New inserts add a permanent mounting for diffusers or polariser’s on lights. The new mounting allows diffusers and polariser’s to be installed in the field.

Inserts - “push in”
Smart Vision Lights recommends installing the brass inserts with a blunt object. The inserts are best installed in the bottom of the slot see figure 1. The insert can be installed by pushing the inserts into the slot from the side see figure 2. Heating the insert with a heat gun will help with less force and an easier install. If heating is used, heat the insert. DO NOT heat plastic housing on the light.

Insert at bottom of slot ready to be pushed in	Pushing insert into Housing

Installing the diffuser or polariser
Use 6 inserts/screws for a Linear light and 3 inserts/screws for a Brick light. Snug down screws to diffuser or polariser. Over tightening screws can break diffuser/polariser or inserts will begin to pull toward surface. Do not over tighten with excessive force. For added stability on a permanent installation, a thread locking compound may be used on the screw.

Correctly installed insert	Correctly installed insert insert & screw