(Please call for the price)
Adjustable Dark Field Ring Lights
DFL Light
• Adjustable Dark Field Ring Lights
• Adjustable lights on aluminum extrusion
• Lights adjust 90 degrees – full vertical to horizontal swing
• Large sizes for automated packaging lines
• 300mm x 300mm Area or 600mm x 600mm
• Lights can be connected and strobed together or separate
• Driver built in – No External wiring to a driver
• PNP and NPN Strobe input
• Continuous operation or Strobe mode
• Dimmable via built in potentiometer
• Analog intensity via 0-10VDC signal
• Standard optics provide tight light pattern
 |
Lights adjustable 90 degrees – Full vertical to horizontal swing
|
| Electrical Input: |
Voltage - 24 VDC +/- 10% |
| Analog Intensity: |
The output is adjustable from 10-100% of brightness by a 0 -10 VDC signal |
| Dimmable: |
The output is manually adjustable from10-100% of brightness by potentiometer |
| Continuous: |
Mode Light will be in continuous mode by leaving signal on strobe input |
| Strobe: |
PNP ? +5VDC or greater to activate | NPN ? GND (<1VDC) to activate |
| Strobe Mode: |
The Light will operate in either continuous or strobe mode. In strobe mode, the output pulse width will track the pulse width of the strobe pulse. |
Wiring:
Smart Vision Lights cables are 5 conductors M12 in 18AWG wire. 18AWG is recommended for ALL OverDrive series and standard series lights. 18AWG is necessary to strobe lights at full current. Common M12 cables are 22AWG. Standard 22 AWG wires will not supply full power needed for our light. Smart Vision Lights recommends the cable from the power supply to the light be kept to a minimum.
• 5 pin Standard M12 mating cable must be used.
• 0 – 10 VDC Analog controls intensity of light from 10-100%. 0VDC = 10%, 10VDC = 100%
• PNP and NPN strobe – In strobe mode the light output will track the pulse width of the strobe input.
• Continuous mode – Leaving the NPN or PNP strobe signal in an active ON state. Non-OverDrive Lights.
